Oce VarioLink 2221 - Specifying Whether or Not the Destination Name Is Inserted (Mode 001)

10
Specifying management settings
10-32 VarioLink 2221/2821/3621
Specifying whether or not the destination name is inserted (mode 001)
Select whether or not the destination name is inserted as transmission
source information.
Factory settings
Specifying settings
The shaded cells indicate the factory settings. The page numbers on the right
side refer to the descriptions for the corresponding function.
Bit 7 6 5 4 3 2 1 0
Setting 0 0 0 1 0 1 0 0 (HEX: 14)
Bit Description Setting Description Page Ref-
erence
7, 6, 5,
4, 3, 2, 1
-------
000101
0
*Do not change these bits
when specifying settings for
this function.
-------
0 Specifies whether or not the
destination name is inserted.
0 The destination name is not
inserted.
-------
1 The destination name is in-
serted.