Oce VarioLink 2221 - Changing or Deleting a One-Touch Dial Button

Scan to E-Mail
4
VarioLink 2221/2821/3621 4-35
Changing or deleting a one-touch dial button
1 Perform steps 1 through 4 of the
procedure in "To program a one-
touch dial button".
2 Touch the one-touch dial button to be change or deleted.
– If the specified one-touch dial button is programmed as an
administrator forwarding destination, the screen for entering the
administrator number appears.
3 Touch the button for the information
to be changed, and then make the
change.
– To delete the information, touch
[Delete], check that the correct
information is to be deleted, and
then touch [OK].
4 Check the information to be registered, and then touch [Enter].
5 Touch [Enter] until the initial screen appears.