Oce VarioLink 2221 - Blocking Calls from Callers that Are Not Specified (Mode 306)

10
Specifying management settings
10-36 VarioLink 2221/2821/3621
Blocking calls from callers that are not specified (mode 306)
This mode can be set if the optional fax kit is installed. Specify whether or not
only faxes (G3) received from callers with a specified F-code (bulletin
board/confidential/forwarding) can be received and all other faxes (G3) are
blocked.
Factory settings
Specifying settings
The shaded cells indicate the settings selected during production.
2
Note
If bit 7 is set to "1", a setting for "All Other Documents" (displayed by
touching [Admin. 1], then [RX Document]) cannot be specified.
Bit 7 6 5 4 3 2 1 0
Setting 0 0 0 0 0 0 0 0 (HEX: 00)
Bit Description Setting Description Page
Refer-
ence
7 Specifies whether or not to
block calls from callers that
are not specified.
0 Does not block ---------
1Blocks
6, 5, 4, 3,
2, 1, 0
-----------------------------
0000000 *Do not change these bits
when specifying settings for
this function.
---------