Oce VarioLink 2221 - Specifying Settings for the Image in the Results Report (Mode 023)

10
Specifying management settings
10-34 VarioLink 2221/2821/3621
Specifying settings for the image in the results report (mode 023)
Specify whether or not an image of the transmitted document is added to the
results report.
Factory settings
Specifying settings
The shaded cells represent the factory settings. The page numbers on the
right refer to the descriptions of the corresponding functions.
Bit 7 6 5 4 3 2 1 0
Setting 1 1 1 1 1 0 0 0 (HEX: F8)
Bit Description Setting Description Page Refer-
ence
7, 6, 5, 4 -----------------------
1111 *Do not change these bits
when specifying settings
for this function.
----------
3 Specifies whether or
not an image of the
transmitted docu-
ment is added to the
results report.
0 Is not added ----------
1 Is added
2, 1, 0 -----------------------
000 *Do not change these bits
when specifying settings
for this function.
----------