Oce VarioLink 2221 - Page 197

Scan to SMB
6
VarioLink 2221/2821/3621 6-27
5 Touch the one-touch dial button to
be programmed.
– Touch an Index tab or [Index
List], then the desired one-touch
dial button.
– If the machine is set to allow
LDAP searches, a screen
appears, allowing you to permit
or prohibit the address registered
with the one-touch dial button to be found with an LDAP search. If
LDAP searches are not to be allowed, select "No".
6 Type in the destination name that will
appear on the one-touch dial button,
and then touch [Next].
7 Select the communication mode.
Touch [PC], [SMB], then [Next].
– If mode 476 of the software
switch settings was changed,
only communication modes that
can be selected appear. For
details, refer to "Specifying
software switch settings
(machine functions)" on
page 10-28.
8 Enter the destination host address,
and then touch [Next].
– To change the host name, touch
[Host Name], and then touch
[Next].
– To reenter an address, touch
or to move the cursor,
or press the [C] (clear) key to
enter a new address.