Oce VarioLink 2221 - Page 406

10
Specifying management settings
10-58 VarioLink 2221/2821/3621
Specifying settings
The shaded cells represent the factory settings. The page numbers on the
right refer to the descriptions of the corresponding functions.
*1
If bit 6 is set to "1", the settings will not be applied if bit 5 is set to "1" (not
displayed). If you do not wish to display the fax number or address of the
recipient, bit 6 must also be set to "1" (settings can only be specified in
Administrator mode).
*2
If the recipient is directly specified from the Direct Input tab, the recipient
is displayed, even if "1" (not displayed) is selected.
Bit Description Setting Description Page Refer-
ence
7 Specifies whether or
not the use of the
computer (scanner)
is prohibited.
0 Permitted ----------
1Prohibited
6 Specifies whether
settings for register-
ing mail addresses
or printing reports
can be specified by
only the administra-
tor or also by the us-
er.
0 Settings can also be
specified by users.
page 10-17
1 Settings can only be
specified in Administrator
mode.
5 Specifies whether or
not only recipient
names are displayed
(and the fax number
or address is not
displayed) in reports
and Job List screens
and when a one-
touch dial button is
touched.
*
1,
*
2
0 Displayed ----------
1 Not displayed
4 -----------------------
0 *Do not change this bit
when specifying settings
for this function.
----------
3 Specifies whether or
not the use of TCP-
Socket is prohibited.
0 Permitted ----------
1Prohibited
2, 1, 0 -----------------------
000 *Do not change these bits
when specifying settings
for this function.
----------