OmniPod 5 - 9 Pausing and Starting Insulin Delivery; 9.1. Pausing Insulin Delivery; 9.2. Methods to Temporarily Pause Insulin Delivery in Manual Mode; 9.3. Starting Insulin Delivery

103
Temporary Basal Rates and Presets 77 Temporary Basal Rates and Presets
e calculations for the 50% increase temp basal in the example above gure are:
Segment
boundaries*
Basal rate of
Basal
Programme
(U/hr)
50% increase
(U/hr)
Resulting temp
basal rate:
(U/hr)
Midnight–7:00 am 0.20
7:00 am–10:00 am 0.20 0.20 x 50%=0.10 0.20 + 0.10 = 0.30
10:00 am–2:00 pm 0.60 0.60 x 50%=0.30 0.60 + 0.30 = 0.90
2:00 pm–4:30 pm 0.30 0.30 x 50%=0.15 0.30 + 0.15 = 0.45
4:30 pm–midnight 0.30
* Segments are dened by the currently scheduled Basal Programme.
Temp basal limitations
Prohibited temp basals: You cannot set a temp basal of 0%, as there would be no
change from the Basal Programme in progress.
Maximum temp basal:
• When using a percentage (%), you can set the temp basal up to 95% more
than your Basal Programme in progress's rate with the following exception:
You cannot set a temp basal that would go above your Maximum Basal Rate
during any time segment covered by the temp basal duration.
• When using a at rate (U/hr), you cannot set a temp basal above your
Maximum Basal Rate.
Temp basals that turn o basal insulin delivery: When using a percentage (%),
if you set a decrease that results in a ow of less than 0.05 U/hr for a segment, the
Omnipod 5 App informs you that you will receive 0 U/hr of insulin for one or
more segments.
If the temp basal is long enough, you will eventually receive some insulin. is is
because the Pod delivers insulin in 0.05 U pulses.
For example, if the ow rate for a basal segment is 0.10 U/hr and you create a temp
basal with a 60% decrease for:
• One hour, the resulting ow rate of 0.04 U/hr results in no insulin being
delivered for the one-hour duration of the temp basal.
• Two hours, the resulting ow rate of 0.04 U/hr results in the delivery of 0 U
insulin in the rst hour and 0.05 U insulin in the second hour.
You can set a temp basal to turn o basal insulin delivery for a set period of time by
using a 100% decrease or a at rate of 0 U/hr. e Pod beeps at the start and end of
a temp basal period of no basal insulin. You can still deliver boluses when using a
temp basal to turn o basal insulin delivery.