OmniPod 5 - Basal and Temp Basal Settings; Maximum Basal Rate; Temp Basal

123
Changing Settings 1010 Changing Settings
10.3. Basal and Temp Basal Settings
e following sections describe how to change settings that control basal insulin
delivery.
Note: ese settings only apply when using Manual Mode.
Maximum Basal Rate
e Maximum Basal Rate denes an upper limit for any basal rate used in your
Basal Programmes and temp basals during Manual Mode only. Consult your
healthcare provider before changing this setting.
To change your Maximum Basal Rate:
1. Navigate to: Menu button ( ) > Settings > Basal & Temp Basal > Max
Basal Rate.
2. Tap the Max Basal Rate eld and enter the new value for your Maximum
Basal Rate.
3. Tap SAVE.
Note: You cannot set a Maximum Basal Rate that is lower than the highest basal
rate of an existing Basal Programme, temp basal preset or currently running temp
basal.
Temp Basal
To turn ON or OFF the ability to set temp basals:
1. Navigate to: Menu button ( ) > Settings > Basal & Temp Basal.
2. To enable or disable the ability to set temporary basal rates (temp basals), tap
the toggle ON or OFF.
3. To change between using percentage (%) and at-rate (U/hr) temp basals:
a. Tap Temp Basal.
b. Select the desired method for setting a temp basal:
• Tap Percentage (%) to modify the Basal Programme in progress by
a set percentage increase or decrease.
• Tap Flat Rate (U/hr) to replace the Basal Programme in progress with
a xed basal rate for the specied duration.
c. Tap SAVE.