Omron RX Series - Page 499

8 - 23
8 Communications Functions
High-function General-purpose Inverter 3G3RX-V1 User’s Manual (I578-E1)
8-5 Modbus Communication Register Number List
8
8-5-1 Coil Number List
*1 Normally, this is ON when the control circuit terminal block input or the coil is ON.
In this case, however, priority for the multi-function input terminals is given to the control circuit terminal block.
If the ON status of a coil cannot be reset from the master due to communications disconnection, turning the control circuit
terminal block from ON to OFF switches the coil to the OFF status.
Coil No.
Modbus
coil
spec. No.
Item R/W Description
000B hex 000A hex Multi-function input terminal S5 R/W
1: ON
0: OFF
*1
000C hex 000B hex Multi-function input terminal S6 R/W
1: ON
0: OFF
*1
000D hex 000C hex Multi-function input terminal S7 R/W
1: ON
0: OFF
*1
000E hex 000D hex Multi-function input terminal S8 R/W
1: ON
0: OFF
*1
000F hex 000E hex Operation status R
1: Run
0: Stop (Interlocked with d003)
0010 hex 000F hex RUN direction R
1: Reverse
0: Forward (Interlocked with d003)
0011 hex 0010 hex Inverter ready R
1: Ready
0: Not ready
0012 hex – Not used – –
0013 hex 0012 hex RUN (Signal during RUN) R
1: During RUN
0: Normal
0014 hex 0013 hex FA1 (Constant speed arrival signal) R
1: ON
0: OFF
0015 hex 0014 hex FA2 (Set frequency exceeded signal) R
1: ON
0: OFF
0016 hex 0015 hex OL (Overload warning) R
1: ON
0: OFF
0017 hex 0016 hex OD (Excessive PID deviation) R
1: ON
0: OFF
0018 hex 0017 hex AL (Alarm signal) R
1: ON
0: OFF
0019 hex 0018 hex FA3 (Set-frequency only signal) R
1: ON
0: OFF
001A hex 0019 hex OTQ (Overtorque/Undertorque signal) R
1: ON
0: OFF
001B hex 001A hex IP (Signal during power interruption) R
1: ON
0: OFF
001C hex 001B hex UV (Signal during undervoltage) R
1: ON
0: OFF
001D hex 001C hex TRQ (Torque limit) R
1: ON
0: OFF
001E hex 001D hex RNT (RUN time over) R
1: ON
0: OFF