Omron RX Series - Page 500

8 Communications Functions
8 - 24
High-function General-purpose Inverter 3G3RX-V1 User’s Manual (I578-E1)
Coil No.
Modbus
coil
spec. No.
Item R/W Description
001F hex 001E hex ONT (Power ON time over) R
1: ON
0: OFF
0020 hex 001F hex THM (Electronic thermal warning) R
1: ON
0: OFF
0021 hex – Not used – –
0022 hex – Not used – –
0023 hex – Not used – –
0024 hex – Not used – –
0025 hex – Not used – –
0026 hex 0025 hex BRK (Brake release) R
1: ON
0: OFF
0027 hex 0026 hex BER (Brake error) R
1: ON
0: OFF
0028 hex 0027 hex ZS (0-Hz detection signal) R
1: ON
0: OFF
0029 hex 0028 hex DSE (Excessive speed deviation) R
1: ON
0: OFF
002A hex 0029 hex POK (Position ready) R
1: ON
0: OFF
002B hex 002A hex FA4 (Set frequency exceeded signal 2) R
1: ON
0: OFF
002C hex 002B hex FA5 (Set-frequency only signal 2) R
1: ON
0: OFF
002D hex 002C hex OL2 (Overload warning 2) R
1: ON
0: OFF
002E hex 002D hex
FVDc (Analog FV disconnection
detection)
R
1: ON
0: OFF
002F hex 002E hex
FIDc (Analog FI disconnection
detection)
R
1: ON
0: OFF
0030 hex 002F hex
FEDc (Analog FE disconnection
detection)
R
1: ON
0: OFF
0031 hex – Not used – –
0032 hex 0031 hex FBV (PID feedback comparison signal) R
1: ON
0: OFF
0033 hex 0032 hex
NDc (Communications disconnection
detection)
R
1: ON
0: OFF
0034 hex 0033 hex LOG1 (Logic operation output 1) R
1: ON
0: OFF
0035 hex 0034 hex LOG2 (Logic operation output 2) R
1: ON
0: OFF
0036 hex 0035 hex LOG3 (Logic operation output 3) R
1: ON
0: OFF
0037 hex 0036 hex LOG4 (Logic operation output 4) R
1: ON
0: OFF
0038 hex 0037 hex LOG5 (Logic operation output 5) R
1: ON
0: OFF