Omron ZW-7000 Series - Offline Debugging of the Sensor Control Program and Sensor Operation

Changing between Online and Offline
184
ZW-7000/5000
User's Manual
6-3 Changing between Online and Offline
Before you go offline, save all settings and parameter changes to the Sensor's internal memory. Saving your
project does not save the data in the Sensor.
You can use the following two methods to change between offline and online.
 Multi View Explore : [(Sensor Name)] (right click)| [Online]/[Offline]]
 Multi View Explore : [Device group] | [(Sensor model)] (Double-click)
→ Edit pane : [On
line] Icon | [Sensor connection] | [Connect] or [Disconnect]
1 To go offline, click [Disconnect]. To go
online, click [Connect].
2 When you click [Connect], the Sensor
Controller with the specified IP address is
connected. When the connection is
successful, Sensor Controller information is
displayed.
3 When you click [Connect], you must
synchronize the data between the Sensor
and the project.
When a project setting data is synchronized with
Sensor Control
ler, select [Transfer to Sensor].
When synchronize a Sensor Controller's setting
d
ata wi
th project, select [Sensor to Transfer].
Saving the Bank/System Settings p.165, p.237
Saving a project p.86
Note