Setting Sensing
210
ZW-7000/5000
User's Manual
Setting the Measurement Area
Setting the Measurement Area p.122
As an example, here is an explanation of the procedure for
selecting "2 area mode" for area mode setting.
Operating procedure
Steps Key operation Display Description
1 Press and hold the key for two seconds to enter the FUNC
mode.
2 Press the / keys to select “SENS” and press the key.
3 Press the / keys to select “REG.MODE” and press
the
key.
4 Set the Area mode.
1.MODE: 1 Area mode
2.MODE: 2 Area mode
Current setting value is displayed on the sub-display.
Press / key to enter editing mode and the sub-display blinks.
In this example, select “2.MODE” and press the
key.
5 Press the key for two seconds to enter the RUN mode.
To save the setting, refer to "7-2 Functions of Operating Keys"
(p.197).
To Next Page
Loading...
