Omron ZW-7000 Series - Setting Area Follow

Setting Sensing
ZW-7000/5000
User's Manual
211
Sensor controller operations
7
Setting Area follow
Area Followp.123
As an example, here is an explanation of the procedure for setting the upper line and lower line of the following
edge t
o follow the reference edge.
Operating procedure
Steps Key operation Display Description
1
Press and hold the key for two seconds to enter the FUNC
mode.
2 Press the / keys to select “SENS” and press the key.
3
Press the / keys to select “FOLLOW” and press the
key.
4
Press the / keys to select “MOdE” and press the
key.
5
Set the Area mode.
1.MODE: 1 Area mode
2.MODE: 2 Area mode
Current setting value is displayed on the sub-display.
Press / key to enter editing mode and the sub-display blinks.
In this example, select “2.MODE” and press the
key.
6
Press the key for two seconds to enter the RUN mode.
To save the setting, refer to "7-2 Functions of Operating Keys"
(p.197).