Omron ZW-7000 Series - Attaching the Strap to Protective Cap; Connection of Fiber Cable and Calibration ROM

Installation
ZW-7000/5000
User's Manual
2
Installation and Connections
55
Attaching the Strap to Protective Cap
1 Attach the supplied strap to the protective cap.
• When attaching the protective cap with its strap to the fiber cable, be careful so as the protective cap or strap do not
catch when you thread it.
• When removing the fiber cable from the Controller, make sure its protectiv
e cap is attached.
Leaving the cable unprotected can let dirt get on the end surfac
e and cause performance deterioration.
• When you remove the protective cap of fiber connector, keep the p
rotective cap using optional strap.
Connection of Fiber Cable and Calibration ROM
Connect the fiber connector of Sensor Head to the fiber adapter of Sensor Controller.
1 Remove the Protective cap of Fiber cable.
l ZW-7000 Series
Important
l ZW-7000 Series l ZW-5000 Series