Omron ZW-7000 Series - Page 58

Installation
56
ZW-7000/5000
User's Manual
2 Connect the Fiber cable and Cariblation ROM to the Sensor Controller.
l ZW-7000 Series
Mate the convex section on the fiber connector with the groove on the fiber adapter.
Make sure to have the bush section of the Fiber cable when you connect to the Fiber cable.
If you have connector section of Fiber connector, cannot be connected correctly.
Reference
If the resolution of PC is low, the light reception wave
might no
t be displayed. In this case, close displayed
item, measurement result, LED light and I/O input.
When install the Fiber cable
In right figure, have the bush section of fiber cable.
Ma
te th
e convex of fiber connector with the groove on
the fiber adapter.
Groove of fiber
adapter
Fiber
adapter
Fiber cable
Bush section
Fiber connector
Convex of fiber connector
Convex of fiber
connector
Cariblation
ROM
Important