Omron ZW-7000 Series - Basic Operations for Displaying Measurement Results

Basic Operation Flow
ZW-7000/5000
User's Manual
23
1
Basic configuration
1-2 Basic Operation Flow
The following is the basic operation flow for ZW-7000/5000 Series.
Installation and connection
Section 2
4-2
4-3
Preparation
for measurement
Setting
measurement
items
Setting output
processing
Saving settings
Install the sensor head.
Default settings for connecting
the sensor head.
Set the extension fiber cable length.
Perform a sensor head calibration.
Setting the scaling
Setting the hold
Setting the Zero Reset
Saving the setting data (*1)
Save the set data.
Setting measurement items
Select task(s) from TASK1 to
TASK4, and set measurement
items, including height, thickness
and calculation.
Setting Measurement Items
Setting the Output Conditions
Installation and Connections
Section 2 Installation and Connections
Section 4 Settings for Functions
Section 4 Settings for Functions
4-3 Setting the Output Conditions
Section 4 Settings for Functions
4-3 Setting the Output Conditions
Section 4 Settings for Functions
3-7 Saving a Project
Section 3 Basic Operation
(*1) After you have made or changed settings,
be sure to save the setup data.
All set data will be cleared if you turn the
power OFF without saving the data.