Omron ZW-7000 Series - Setting the Zero Reset

Setting the Output Conditions
230
ZW-7000/5000
User's Manual
Setting the Zero Reset
Setting the Status
Setting the Status p.152
As an example, here is an explanation of the procedure for selecting the “ON” (Enabled) zero reset type setting.
Operating procedure
Steps Key operation Display Description
1 Press and hold the key for two seconds to enter the FUNC
mode.
2 Press the / key to select MEAS, then press the key.
3 Press the / key to select TASK1, then press the key.
4 Press the / keys to select “OUTPUT” and press the
key.
5 Press the / keys to select “ZERO” and press the
key.
6 Press the / keys to select “STATUS” and press the
key.
7 Set zero reset ON/OFF.
The current setting value is displayed on the sub-display.
Press / key to enter editing mode and the sub-display blinks.
In this example, select “ON” and press the
key.
8 Press the key for two seconds to enter the RUN mode.