Omron ZW-7000 Series - Setting Exposure Time Control Mode

Setting Sensing
ZW-7000/5000
User's Manual
209
Sensor controller operations
7
Setting Exposure Time Control Mode
Setting Light Exposure Time Control Mode p.121
As an example, here is an explanation of the procedure for setting the exposure time control mode to "AUTO"
and cont
rol edge of light adjustment to "measurement area 1".
Operating procedure
Steps Key operation Display Description
1 Press and hold the key for two seconds to enter the FUNC
mode.
2 Press the / keys to select “SENS” and press the
key.
3 Press the / keys to select “LIGHT” and press the
key.
4 Select the exposure time control mode.
AUTO: Automatic
MANUAL: Fixed
The current setting value is displayed on the sub-display.
Press / key to enter editing mode and the sub-display blinks.
In this example, select “AUTO” and press the
key.
5 Set the Control edge.
In this example, “ADJ.SUR” is displayed on the main display, and the
current
setting value is displayed on the sub-display.
Press key to enter the editing mode, and the sub-display
blinks.
To edit numerical values, use the / / / keys.
In this example, select “EDGE1” and press the
key.
6 Press the key for two seconds to enter the RUN mode.