Omron ZW-7000 Series - Setting Start Direction of Count Measurement Surfaces

Setting Sensing
208
ZW-7000/5000
User's Manual
Setting Start Direction of Count Measurement Surfaces
Setting Start Direction of Count Measurement Surfaces p.120
As an example, here is an explanation of the procedure for setting start direction of count measurement surface
to “N
EAR”.
Operating procedure
Steps Key operation Display Description
1 Press and hold the key for two seconds to enter the FUNC
mode.
2 Press the / keys to select “SENS” and press the
key.
3 Press the / keys to select “SUR.DUR” and press the
key.
4 Select the material.
NEAR: NEAR direction
FAR: FAR direction
The current setting value is displayed on the sub-display.
Press / key to enter editing mode and the sub-display blinks.
In this example, select “NEAR” and press the
key.
5 Press the key for two seconds to enter the RUN mode.