Omron ZW-7000 Series - Bank Switching; Multi-Task and Bank Data

Bank switching
110
ZW-7000/5000
User's Manual
3-9 Bank switching
Multi-task and Bank Data
Multi-task Function
With the ZW-7000/5000 Series, you can set multiple measurement processing for one sensing setting. This
measurement processing is called a “task (TASK).”
Example: When measuring height and side run-out at the same time
For tasks, TASK1 to TASK4 are available for registration.
You can measure and judge up to four characteristic points simultaneously because you can specify the
desired meas
urement items such as height, thickness, and calculation for each task.
Height (TASK1)
Surface fluctuation (TASK2)
Measurement processing flow in TASK1
- Analog output
Select one TASK that you want to output.
- Judgment output
Select one TASK that you want to output.
- Serial output (Ethernet/RS-232C)
Allows output of four data of the following:
Results of TASK1 to TASK4, exposure
time, peak value of received light.
- Fieldbus output (EtherCAT / EtherNet/IP)
Allows output of four data of the following:
Results of TASK1 to TASK4, exposure
time, peak value of received light.
Sensing setting
Measurement processing flow in TASK4
Measurement item
Filter
Scaling
Hold
Zero reset
Judge
Measurement item
Filter
Scaling
Hold
Zero reset
Judge
Output * Output *
Measurement result
* For the output, the following four types are
supported: