Setting Measurement Items
ZW-7000/5000
User's Manual
125
4
Settings for Function
4-2 Setting Measurement Items
What is a Measurement Item?
Obtain the waveform data based on the specified sensing condition, and calculate the height/thickness of up to
four surfaces included in the measuring range. Perform calculations using the output result of each task.
Count the measurement surface closest to the Sensor Head first (default value).
Measuring the Height
The count direction for measurement surfaces can be changed.
Setting Start Direction of Count Measurement Surfaces p.120
Sensor head
Edge 1st
Edge 2nd
Edge 3rd
Edge 4th
Note
The setting for common height
measurements as shown in the
following diagram is registered
for TASK1 in advance. In such
a case, this setting is not required.
Set this item when measuring
the height of an object below
a transparent object as shown
in the following diagram.
Edge 1st
Height
Edge 1st
Edge 2nd
Measurement
range
Transparent
object
Sensor head
Sensor head
To Next Page
Loading...
