Setting the Banks
238
ZW-7000/5000
User's Manual
Clearing the Bank Settings
Clear (initialize) the setting of the currently selected bank.
Clearing the Bank Settings p.168
Operations on the Sensor Controller do not initialize system settings and settings displayed in RUN mode.
Operating procedure
Steps Key operation Display Description
1 Press and hold the key for two seconds to enter the FUNC
mode.
2 Press the / key to select BANK, then press the key.
3 Press the / keys to select “BK.CLR” and press the
key.
4 “OK/CAN” is displayed on the sub-display.
Press the key to clear the settings or the key to
cancel.
5 Press the key for two seconds to enter the RUN mode.
Important
To Next Page
Loading...
Need help?
General
