Omron ZW-7000 Series - Starting up Sysmac Studio Measurement Sensor Edition

Basic Operations for Displaying Measurement Results
34
ZW-7000/5000
User's Manual
Starting Up Sysmac Studio Measurement Sensor Edition
4 Click the [OK] button to establish a connection to the Sensor Controller.
3 Basic Operation p.87
1 Start up Sysmac Studio.
2 Create a new project for the ZW.
From Category, select [Measurement Sensor]
and fr
om Device, select [ZW] to click the [Cre-
ate] button.
If you have a previously created project, click [Open Project] to select the project.
2-8 Saving a project p.86
3 Select the [Specify a sensor] button to spec-
ify the IP address of the Sensor Controller to
be co
nnected.
Click the [Confirm] button to confirm the infor-
mation of the Sensor Controller.
When connection with Sensor Controller is suc-
cessful, Sensor Controller information is dis-
played.
Click [OK] button, the Sensing monitor window
a
ppears
.
Edit pane p.83
By default, the Sensor Controller has an IP address of 192.168.250.50
For the basic operations of Sysmac Studio, refer to “Sysmac Studio Versio
n 1 Operation Manual” (W504).
Note
Note
Note