Omron ZW-7000 Series - Part Names and Functions; Sensor Head; Calibration ROM

2
Installation and Connections
Part Names and Functions
ZW-7000/5000
User's Manual
43
2-2 Part Names and Functions
The following describes the names and functions of parts of the Sensor Head, Calibration ROM and Sensor
Controller.
Sensor Head
Calibration ROM
This ROM is associated with the sensor on a one-to-one basis, and operates connected to the Sensor
Controller.
Use with the Calibration ROM always connected. If the Calibration ROM is not connected, the error message
“SYSERR” is shown
in the main digital and “NO.ROM” is shown in the sub digital, where measurement is not
possible.
If the Calibration ROM is lost, or fails, refer to p.174.
“6-1 Error Messages” described in Displacement Sensor ZW-7000/5000 series Confocal Fiber Type
Disp
lace
ment Sensor User’s Manual for Communications Settings (Z363)
No. Names Functions
1 Projector/receiver Projects and receives light.
2 Serial number. Serial number.
Only a calibration ROM with the same serial number is available.
3 Fiber interface Interfaces the Sensor Head and optical fiber.
(Do not remove this fiber interface. If you remove it, repair may be needed.)
4 Fiber Cable Sends or receives light signals to/from the Sensor Controller.
5 Fiber Connector Couples the Sensor Controller and fiber cable.
No. Names Functions
1 Serial number Serial number.
Only a Sensor Head with the same serial number is available.
1
2
3
4
5
1
2
3
4
5
l ZW-S70@0
l ZW-S50@0
1
Important