Omron ZW-7000 Series - Functions and Operations during Measurement

Functions and Operations during Measurement
ZW-7000/5000
User's Manual
201
Sensor controller operations
7
7-5 Functions and Operations during Measurement
Switching the RUN (Run) Mode Display
In the RUN mode, you can switch the measured value display by pressing the / keys during the operation.
You can check the threshold value and analog output value while displaying the m
easured value on the main display.
The above display screenshots are only samples and may different from actual displays.
(Note 2) An output item not selected on th
e analog output (Voltage output/Current output) is displayed as “------
” on the sub-display. For example, if “Voltage output” is selected on the analog output, the analog
current output value is displayed as “------” on the sub-display.
(Note 3)
“Displayed task” can be selected from TASK1 to TASK4. “Task for displayed target” is displayed as “dTASK @ .”
@ indicates the task number. (Refer to p.204 for the task for displayed target.) ) If the task for displayed
target is TASK2, for example, “TASK1,” “dTASK2,”
“TASK3” and “TASK4” will be displayed.
H lit
L unlit
H unlit
L lit
HIGH threshold value
Analog voltage
output value
Judgment result
Analog current
output value
H unlit
L unlit
H unlit
L unlit
H unlit
L unlit
H unlit
L unlit
Resolution
（
Note 3
）
（
Note 2
）
LOW threshold value
Amount of emitted
light
H unlit
L unlit
Distance
H unlit
L unlit
Distance
H unlit
L unlit
Displayed Task for
displayed target
H unlit
L unlit
Displayed Task for
displayed target
H unlit
L unlit
Online status
Tag link status
H unlit
L unlit
H unlit
L unlit
Tag link status
H unlit
L unlit
H unlit
L unlit
Internal logging status
H unlit
L unlit
Amount of light
received