Omron ZW-7000 Series - Setting Sensing; Set the Measurement Cycle

Setting Sensing
206
ZW-7000/5000
User's Manual
7-6 Setting Sensing
Set the Measurement cycle
Setting the Measurement Cycle p.116
As an example, here is an explanation of the procedure fo
r setting the measurement cycle to "400 ms".
Operating procedure
Steps Key operation Display Description
1 Press and hold the key for two seconds to enter the FUNC
mode.
2 Press the / keys to select “SENS” and press the
key.
3 Press the / keys to select “CYCLE” and press the
key.
4 Set the measurement cycle.
Press key to enter the editing mode, and the sub-display
blinks.
To edit numerical values, use the / / / keys.
In this example, select “000400” and press the
key.
5 Press the key for two seconds to enter the RUN mode.