Setting Measurement Items
212
ZW-7000/5000
User's Manual
7-7 Setting Measurement Items
Measuring the Height
Measuring the Height p.125
As an example, here is an explanation of the procedure for measuring the height of the surface (2nd surface)
below
a transparent object (as shown in the diagram on p.125).
Operating procedure
Steps Key operation Display Description
1 Press and hold the key for two seconds to enter the FUNC
mode.
2 Press the / key to select MEAS, then press the key.
3 Press the / key to select TASK1, then press the key.
4 Press the / keys to select “ITEM” and press the key.
5 Press the / keys to select “HEIGHT” and press the
key.
6 Select the measurement surface.
EDGE1 to EDGE4: 1st surface to 4th surface
PEAK: Peak
“SUR” is displayed on the main display and the current setting value
is di
spla
yed on the sub-display.
Press / key to enter editing mode and the sub-display blinks.
In this example, select “EDGE2” and press the
key.
7 Press the key for two seconds to enter the RUN mode.
To Next Page
Loading...
