Omron ZW-7000 Series - Connecting with EtherCAT

Setting the System
ZW-7000/5000
User's Manual
247
Sensor controller operations
7
Setting the extension fiber cable length.
Here is an explanation of the procedure for setting the extension fiber cable length to "10m".
Operating procedure
Steps Key operation Display Description
1 Press and hold the key for two seconds to enter the FUNC
mode.
2 Press the / keys to select “SYSTEM” and press
the
key.
3 Press the / keys to select “CABLE” and press
the
key.
4 Select the extension fiber cable length.
The current setting value is displayed on the sub-display.
Press / key to enter the editing mode and the sub-display
blinks.
In this example, select "10M" and press the
key.
5 Press the key for two seconds to enter the RUN mode.
For how to save settings, refer to 7-2 Functions of Operating Keys
p.197.