Omron ZW-7000 Series - Setting the Banks; Switching Banks

Setting the Banks
234
ZW-7000/5000
User's Manual
7-9 Setting the Banks
Switching Banks
Switching Banks p.112
As an example, here is an explanation of the procedure for setting BANK2.
Operating procedure
Steps Key operation Display Description
1 Press and hold the key for two seconds to enter the FUNC
mode.
2 Press the / key to select BANK, then press the key.
3 Press the / key to select BK.CHG, then press the
key.
4 Select BANK2 for the bank number.
The current setting value is displayed on the sub-display.
Press / key to enter editing mode and the sub-display blinks.
Select “BANK2” and press the
key.
5 “OK/CAN” is displayed on the sub-display.
Press the key to save the settings or the key to
cancel.
6 Press and hold the key for two seconds to enter the RUN
mode.