Setting Sensing
124
ZW-7000/5000
User's Manual
Multi View Explorer : [BANK] | [(Bank Data Name)] (double-click)
→ Edit Pane : [Sensing setting] icon ( )
→
Sensing settings window : [measurement area 2] - Area follow settings
An error occurs if Area Teach is executed under the following conditions.
• The reference edge or the following edge cannot be measured
• The reference edge number and the following edge number are the same
Item Setting item Setting value Description
Area follow set-
tings
Area follow None (initial
value)
Area follow is not set. Select this to set any desired value.
Upper line Follows the upper line of Area 2 only.
Lower line Follows the lower line of Area 2 only.
Upper line and
lo
we
r line
Follows the upper line and lower line of Area 2.
Reference edge Edge1/Edge2/
Edge3/
Edge4/
peak
(Initial value:
Edge
1)
Select
the measurement surface of measurement
area 1 to be used as the
reference for automatic tracking.
The peak is the surface of all measurement sur
faces having the highest
received light amount.
Following edge Edge1/Edge2/
Edge
3/Edge
4/
peak
(Initial value:
Edge2)
Select
the measurement surface of measurement area 1 to be the target of
automatic f
ollowing. Measurement area 2 is automatically set based on the
surface selected when [Area Teach] is clicked.
The peak is the surface of all measurement sur
faces having the highest
received light amount.
1
Set [Area follow].
2
Set [Reference edge] and [Following edge].
3
Click [Area Teach].
The area range suitable for measuring the
foll
owing edge is automatically set as Area 2,
then Area follow starts.
To Next Page
Loading...
