Setting the Output Conditions
ZW-7000/5000
User's Manual
231
Sensor controller operations
7
Setting the Offset
Setting the Offset p.153
As an example, here is an explanation of the procedure for
selecting the “10 mm” reference value setting.
Operating procedure
Steps Key operation Display Description
1 to 5 For moving to “ZERO”, see steps 1 to 5 in p.230.
6 Press the / keys to select “OFFSET” and press the
key.
7 Change the offset value.
The current setting value is displayed on the sub-display.
Press key to enter the editing mode, and the sub-display
blinks.
To edit numerical values, use the / / / keys.
In this example, input “10”, then press the
key.
8 The decimal point is displayed.
Press the / key to move the decimal point.
Determine the decimal point and then press the
key.
9 Press the key for two seconds to enter the RUN mode.
To Next Page
Loading...
