Wiring
ZW-7000/5000
User's Manual
2
Installation and Connections
77
Output circuit
*1 NPN/PNP dual type. According to the specifications of the external equipment, ensure proper wiring.
*2 Below is a table giving the COM_OUT (output common) and output signal connection correspondence.
• Connect a load that matches the output specifications. Short-circuit can cause sensor breakdown.
• Keep the load current less than or equal to the specification value
. Exceeding the specification value could cause
damage to the output circuit.
Item Specifications
Model ZW-7000@/5000@
Output type
*1
For NPN connection For PNP connection
Output voltage DC21.6 to 30 V DC21.6 to 30 V
Load current 50 mA max. 50 mA max.
ON residual voltage 2 V max. 2 V max.
ON leakage current 0.1 mA max. 0.1 mA max.
Internal circuit diagram
*2
Terminal name COM_OUT1 COM_OUT2 COM_OUT3
Output signal
name
HIGH BANK_OUT1 STABILITY
PAS S BANK_OUT2 LOGERR
LOW BANK_OUT3 LOGATAT
ALARM SYNCFLG/TRIGBUSY
BUSY TASKSTAT
ENABLE
L
COM_OUT1/2/3
+
Internal
circuit
Output
terminals
Load
L
+
COM_OUT1/2/3
Internal
circuit
Output
terminals
Load
Important
To Next Page
Loading...
