Figure 27: Examples of supported rack holes...........................................................................61
Figure 28: Rails for the DE2-24P Drive Enclosure....................................................................61
Figure 29: Rails for the DE2-24C Drive Enclosure....................................................................62
Figure 30: 10mm wrench and adaptor pins ..............................................................................65
Figure 31: Rack flange, rail flange, and rail label (front)............................................................66
Figure 32: Back-mounting screw...............................................................................................67
Figure 33: Front of the rack and rail-location pegs....................................................................68
Figure 34: A Phillips 13mm head hex flange screw and the front of a rack...............................69
Figure 35: Extended rail to the back of the rack........................................................................69
Figure 36: A Phillips 13mm head hex flange screw and the back of a rack..............................70
Figure 37: Cage nut installed in a square-hole rack..................................................................71
Figure 38: Rail-location pegs from inside of the rail flange and the clip nut..............................72
Figure 39: Rail-location pegs and a square-hole rack...............................................................73
Figure 40: Rail extended to holes in the back of the rack..........................................................73
Figure 41: The locking screws and side of the rail....................................................................74
Figure 42: Pilot rail kit parts.......................................................................................................75
Figure 43: Rack-mount installation card template.....................................................................76
Figure 44: Slide rails oriented with the ball bearing track..........................................................77
Figure 45: Slide rail assembly aligned with the rack..................................................................77
Figure 46: Mounting bracket aligned with the Pilot chassis.......................................................78
Figure 47: CMA slide rail connector inserted into the back of the right slide rail.......................79
Figure 48: CMA slide rail connector inserted into the back of the left slide rail.........................80
Figure 49: The rail ledge for the DE2-24C Drive Enclosure......................................................82
Figure 50: Phillips Number 2 pan head screw with patch lock..................................................82
Figure 51: Left front-side cap and Phillips 13mm head hex flange screw.................................83
Figure 52: Left rail channel........................................................................................................84
Figure 53: Back of the Drive Enclosure and Rail secured.........................................................85
Figure 54: Left front-side cap and Phillips 13mm head hex flange screw.................................86
List of Figures
10