“Cables.”. The component labels help facilitate the assembly of an Oracle FS
System at the customer site and are usually temporary.
Note: While ordering or receiving multiple not-racked Oracle FS Systems, it is
critical to make sure that all shipping cartons are grouped by the top level serial
number. If components from systems with dierent system serial numbers are
mixed, the resulting assembled systems will not boot.
Besides, Drive Enclosures and Controllers have seven segment identication
displays that indicate the chassis ID. The seven segment displays on the Drive
Enclosures and Controllers can be changed by the customer.
Note: To avoid a disconnect between the temporary component label and the
chassis ID displayed on the seven segment display, Oracle recommends
removing the temporary labels after installing a not-racked system.
A Before You Begin document inside the shipping carton provides some basic
instructions for unpacking, cabling, and drive replacement procedures. A generic
Sun Server X3-2 manual is also available in the carton along with an instruction
card for installing the rack rails on the Pilot.
Related Links
Check and Receive Components
System Components
Electrostatic Discharge Precautions
Warnings and Cautions
Required Tools
Check and Receive Components
Check to verify the content of the shipping cartons for the not racked Oracle FS
System prior to unpacking the system components.
1 Check all the shipping cartons for any visible damage.
2 Check the components against the packing list to verify that all
components have been shipped.
Note: Do not unpack all the cartons at once. Otherwise, items might get
misplaced. Also, there might not be enough space in the data center to
open all the boxes together.
3 Organize all of the boxes so that the related components are grouped
together before unpacking the shipment.
For example, organize the Drive Enclosures boxes into one group.
Organize the Controller boxes into another group, and so on. Use the
information on the labels that are applied to the boxes as a guideline for
organizing the groups.
4 Unpack the cables and arrange them in an organized manner with the
labels showing.
Oracle FS Systems: Installation Overview
33
To Next Page
Loading...
Need help?
General