12 Type SCSI and click Send.
13 Type CHK and click Send.
The list of the drives installed on the Drive Enclosure is displayed in the
console. Verify that the drive is back online.
14 Clear the drive failure history.
a) Log in to the Oracle FS System Command Line Interface (fscli).
b) Issue the following command:
fscli enclosure -clearDriveHistory -enclosure
[enclosure-id-or-fqn] -driveSlot X
The enclosure-id-or-fqn is the fully qualied name (FQN) or the
unique identier (ID) of the Drive Enclosure. The FQN includes the
chassis ID, which is displayed on the front of the Drive Enclosure.
Note: The driveSlot value is derived from the HEX value listed in
the Drv column from the results of the SCSI CHK command.
After the command completes, the system returns a success message.
System Status Verification
The status of the installation of the Oracle FS System can be veried using the
Oracle Flash Storage Portal web interface or the Oracle FS System Manager (GUI)
or the FSCLI.
To verify system status on the Oracle Flash Storage Portal, use a web browser on
a computer, tablet, or mobile device that has access to the customer management
network. In the browser, enter the IP address of the Oracle FS System or, if the
system name is resolvable, enter the name of the system. To verify system status
on the Oracle FS System Manager (GUI), download and install the GUI client on
a client workstation with access to the Pilot. Alternatively, you can download and
install the fscli on a workstation with access to the Pilot.
To verify the wiring topology using the fscli, use the following commands:
•
fscli topology -list —enclosure <output-text-filename1.txt>
For example: fscli topology -list —enclosure <sas-encl-
list.txt>
•
fscli topology –download –topomap <output-text-
filename2.txt>
For example: fscli topology –download –topomap <sas-conn-
map.txt>
The topology -list -enclosure command generates an output le containing
the list of Drive Enclosures with their world wide names (WWN) and chassis ID
values. The topology -download -topomap command generates an output le
containing the SAS connection map. Evaluate the output les to determine the
necessary corrections.
Complete the Installation
187
To Next Page
Loading...
Need help?
General