APPENDIX B
Oracle FS System LED Status
Oracle FS System LEDs
An Oracle FS System includes LEDs to indicate the status of the hardware
components. To restore reliability to the Oracle FS System, locate the specic
failed component so that you can replace it. Hardware LED conguration helps
you identify the failed component.
Important: If you cannot locate the hardware component that must be replaced,
contact Oracle Customer Support.
The Guided Maintenance feature of the Oracle FS System Manager triggers the
chassis with the failed component to blink, or it triggers all of the other chassis to
blink, except for the one with the failed component. This blinking paern helps
you to identify component status.
Note: LED interpretations in this appendix apply to a system after it has been
powered on.
Related Links
Pilot LED Indicators
Drive Enclosure LED Indicators
Controller LED Indicators
Controller LED Indicators
The LED alarm assembly is a high-level status indicator of the Controller and
Controller components. Use these diagnostic LEDs to determine if a component
has failed in the Controller. The LED alarm assembly also includes a power
buon to power on the Controller. Besides, the LED alarm assembly there is the
Controller Identication Display (CID) that identies the Controller by its
numeric identier.
The following gure shows the front display panel of the LED alarm assembly
on the Controller:
194
To Next Page
Loading...
Need help?
General