Oracle FS1-2

Figure 20: Slide rail mounted on the rack post
Legend
1 Rack post
2 Slide rail
Tip: Loosely aach the front of a slide rail to the right front rack post using
two screws but do not tighten the screws yet. Adjust the length of the slide
rail by sliding the back mounting ange to reach the outside edge of the
back rack post. Loosely aach the back of the slide rail to the back rack
post with two screws.
8 Aach the second slide rail to the left rack posts in a similar manner.
Tip: Do not tighten the screws.
9 Use the slide rail spacing tool to adjust the distance between the slide rails.
Install Component Rails
55