CHAPTER 13
Connect to the Customer Data Network
Connections to the Customer Data Network
To enable the Controller to serve the customer data stored in the Oracle FS
System, connect the Controller to the customer data network.
SAN HBA cards connect using FC and iSCSI cables to the SAN hosts for SAN
connectivity. The connectors on the SAN HBA are SFP+ or SFP++ and can be
provisioned with the following seings:
•
FC 8-16 Gbs with the appropriate SFPs for optical cables
•
iSCSI 10GbE, with appropriate SFPs for optical cables
Caution: Route the customer data cables through the existing Controller cable
management arm (CMA) and secure the cables within the CMA using the
existing velcro straps. If the cables become snagged while the Controller chassis
is extended to the service position, damage to the system motherboard might
occur.
Related Links
Cabling Workow
Provision the Controller Ports
Types of External Cables
Provision the Controller Ports
The Controller ports are provisioned during the manufacturing process. Prior to
connecting the Oracle FS System to the customer data network, verify that the
Controller ports are provisioned to meet the requirements of your installation.
1 From Oracle FS System Manager (GUI), navigate to System > Global
Seings > Controller Ports
2 Select a Controller.
3 Select Actions > Modify Port Seings.
4 If necessary, modify the protocol properties.
Note: Refer to the Release Notes for a list of the supported protocols for
your release.
5 Click OK.
179
To Next Page
Loading...
Need help?
General