Oracle FS1-2

management workstations. The customer uses the GUI for long-term
management and monitoring of the Oracle FS System.
Prerequisites:
• Management workstations must be on a network that can access the
management IP addresses of the Pilot on port 80 or port 8080.
• Workstations using the Oracle FS System Manager (GUI) or the Oracle FS
Command Line Interface (FSCLI) to manage or monitor the system must be
on a network congured to permit that workstation to reach the Pilot
management IP Ethernet interfaces on port 26012.
• The system is powered on.
• The IP addresses are set on the Pilots.
• For JAVA Archive (JAR) installers, Java 1.7 or higher must be installed on the
workstations.
Note: The Windows MSI installers do not require Java to be installed on the
workstation.
1 From the customer’s management workstation, open a web browser and
enter the IP address or the hostname of the customer management
network.
2 Click Management Software.
3 Select the link for the version of the GUI installer that you want to
download, and save the le.
4 Run the installer to install the software.
Download Oracle FS Command Line Interface
You can use Oracle FS Command Line Interface (FSCLI) to congure and manage
the Oracle FS System. To install FSCLI, download the software from the Pilot and
install the software on the customer’s management workstations.
Prerequisite:
The system is powered on.
1 From the customer’s management workstation, open a web browser and
enter the IP address or the hostname of the customer management
network.
2 Click Management Software.
3 Select the link for the version of the CLI installer that you want to
download and save the le to the workstation.
4 Run the installer to install the software.
Configure and Connect to the Customer Management Network
162