Table 14: Site preparation checklist (continued)
Check Site preparation or pre-installation planning items
❑
Set the operating mode of the management Ethernet: auto-negotiation, or
manual speed and duplex.
❑
Congure the DNS server and backup DNS server for Call-Home.
❑
Get the IP address of your primary NTP server for synchronizing system
time. This is recommended for SAN and required for NAS.
❑
Congure an email server for password recovery and optionally for
sending e-mail notications.
❑
Congure SNMP servers for traps and monitoring.
❑
If a UPS is being used, get the IP address of the UPS device and the UPS
SNMP community string.
Oracle FS System Manager GUI access
❑ Ensure that you have the default customer login and the default support
login.
❑ Download and install the GUI or the command line interface (CLI) or both
from hp://system-name-ip, where system-name-ip is the name or the
public IP address of your system.
SAN storage parameters
❑ Understand enough about SANs to specify capacity, type of redundancy,
priority over other volumes, random or sequential le access, read or write
I/O bias, and Clone LUN space requirements.
Related Links
Not-Racked Systems
Installation Overview
Unpacking Systems
Not-racked Oracle FS System components are shipped in separate cardboard
cartons on a pallet.
Each shipping carton contains the following items taped on the cardboard:
•
Customer system record
•
Product label
•
Component label
Oracle FS Systems: Installation Overview
31
To Next Page
Loading...
Need help?
General