If the version numbers of the drive rmware displayed in Staged Software
and Firmware are higher than the version numbers of the drive rmware
displayed in Installed Software and Firmware, proceed with the following
steps.
3 Select Actions > Update Drive Firmware.
4 Select the Install? checkboxes for each of the drive types with a current
version of rmware that is lower than the pending version of rmware.
5 Click OK.
The system restarts. The drive rmware is installed as the system restarts.
Note: Depending on the number of Drive Enclosures and the number of
drives in the system, the update to the drive rmware can be time
consuming.
6 After the upgrade completes, check that the version numbers of drive
rmware are correct and that the system status is Normal.
Configure and Connect to the Customer Management Network
167
To Next Page
Loading...
