PIAGGIO Beverly 300 i.e. - Removing the Driven Pulley Shaft Bearing; Refitting the Driven Pulley Shaft Bearing

- Undo the three screws «3» and remove the filter
cover in the transmission housing «4».
- Take out the filtering element «5» from the cover.
Removing the driven pulley shaft bearing
- Remove the clip from the inside of the cover.
- Remove the bearing from the crankcase by
means of:
Specific tooling
020376Y Adaptor handle
020375Y 28 x 30 mm adaptor
020412Y 15-mm guide
Refitting the driven pulley shaft bearing
- Heat the crankcase from the inside.
- Insert the bearing in its seat.
- Refit the Seeger ring.
CAUTION
USE AN APPROPRIATE SUPPORT TO AVOID DAMAGING
THE COVER SURFACE.
N.B.
ALWAYS REPLACE THE BEARING WITH A NEW ONE
UPON REFITTING.
Specific tooling
020376Y Adaptor handle
020357Y 32x35-mm Adaptor
Engine Beverly 300 i.e.
ENG - 110