- Check that hydraulic rod caulkings, the return
spring to the unloaded the end of stroke and the
hydraulic rod sealing ring are in good conditions.
- Check that the main spring exhibits no signs of
yielding or abnormal wear.
- Check that the closing cap O-ring of the stem is
in good conditions.
Refitting
- First grease the splitting chamber of the two seal-
ing lips of a new oil seal.
- Fit the sealing ring on the stem and keep the
identification words facing upwards.
- Drive the oil seal as far as it will go using the ap-
propriate tool.
Specific tooling
020376Y Adaptor handle
020359Y 42x47-mm Adaptor
Suspensions Beverly 300 i.e.
SUSP - 210
To Next Page
Loading...
