TRIP COUNTER PARTIAL RESET
In the partial trip counter function, press and hold
the MODE button for longer than 3 seconds and it
will reset.
SELECT MILES - KM
When using the function measuring the voltage of
the battery, holding down the MODE button for
longer than 10 seconds will switch between read-
ing in kilometres or miles for the odometer.
For the first 5 seconds the bearing will not give any
signal, for the next 5 seconds the message of the
unit of measurement (Km or miles) currently in use
will blink at a frequency of 1Hz. If the button is re-
leased before 10 seconds the measurement unit
is not changed.
Beverly 300 i.e. Pre-delivery
PRE DE - 283
To Next Page
Loading...
