- Position the spline clip on the crankshaft and ori-
ent the end as shown in the figure.
- Orient the water pump shaft with reference to the
transmission gear seat as shown in the picture.
- Fit the flywheel cover complete with pump, en-
suring that the alternator cable grommet is fitted
correctly.
- Tighten the ten screws fastening the flywheel
cover, ensuring that the indicated plate is posi-
tioned correctly.
- Reconnect the electric connector on the mini-
mum oil pressure switch.
- Fit the water pipes onto the unions on the pump
cover and tighten the clamps.
Locking torques (N*m)
Flywheel cover screw 11 ÷ 13
Flywheel and starting
Beverly 300 i.e. Engine
ENG - 133
To Next Page
Loading...
