PIAGGIO Beverly 300 i.e. - Components Location

Proceed with the injector seal test.
Dry the injector outlet with a blast of compressed
air. Activate the fuel pump. Wait for one minute,
making sure there are no leaks coming from the
injector. Slight oozing is normal.
Value limit = 1 drop per minute
Components location
COMPONENT LAYOUT
Specification
Desc./Quantity
1 Battery 12V - 10Ah
2 Diagnostics socket connector
3 Electric fan solenoid
4 Injection load solenoid
5 Water temperature sensor
6 Throttle body and electronic injection control unit (MIU)
7 Fuel injector
8 HV coil
9 Lambda sensor
10 Fuel pump
11 Engine Speed sensor
Injection Beverly 300 i.e.
INJEC - 190