PIAGGIO Beverly 300 i.e. - Service Interval Reset and Schedule

RESET SERVICE WARNING LIGHT
At vehicle ignition, immediately after the ignition
check, if there are less than 300 km (187.5 miles)
to the next scheduled service, the corresponding
icon flashes for 5 seconds. Once the service mile-
age has been reached, the icon remains steadily
on until it is reset.
The resetting of the service is done by holding
down the MODE key to the key connection for
more than 10 seconds. For the first 5 seconds, the
instrument panel will not give any signal, for the
next 5 seconds the key icon will blink at a frequen-
cy of 1Hz. If the button is released before the 10
seconds, the service is not reset.
Maintenance chart
MAINTENANCE TABLE
I: INSPECT AND CLEAN, ADJUST, LUBRICATE OR REPLACE, IF NECESSARY C: CLEAN, R: REPLACE, A: ADJUST, L:
LUBRICATE
* Replace every 2 years
** Clean frequently in cases of intensive use on gravel roads
Km x 1,000
1 5 10 15 20 25 30 35 40 45 50 55 60
Driven pulley roller casing L L L L L L
Safety fasteners I I I I
Ignition spark plug R R R R R R
Centre stand bracket L L L L L L L L L L L L
Drive belt R R R R
Throttle control A A A A A A A
Air filter/CVT filter ** C C C C C C
Oil filter R R R R R R R
Valve clearance A A A
Electrical system and battery I I I I I I I
Coolant level * I I I I I I I
Brake fluid * I I I I I I I
Engine oil R I R I R I R I R I R I R
Hub oil R I R I R I R
Brake pads I I I I I I I I I I I I I
Sliding shoes / CVT rollers R R R R R R
Tyre pressure and wear I I I I I I I
Vehicle road test I I I I I I I
Suspension I I I I I I I
Steering A I I I I I I
Time 60' 10' 100' 45' 150' 10' 140' 10' 150' 45' 100' 10' 190'
Maintenance Beverly 300 i.e.
MAIN - 40