Disc Inspection
Checking the disc is important; it must be perfectly
clean, with no sign of rust, oil or grease or any oth-
er dirt, and must show no signs of deep scoring.
Characteristic
New rear disc thickness
4.0 mm
Disc thickness at wear limit (rear)
3.5 mm
- Using the specific tool, check that the axial run-
out of the brake surface is within the prescribed
limits.
- If this is not the case, replace the disc and repeat
the test.
WHEN INSTALLING, THOROUGHLY CLEAN THE DISC
AND ITS SEAT ON THE HUB.
Characteristic
Max. axial run-out
0.1 mm
Front brake disc
Removal
Proceed as follows:
- Remove the front wheel.
- Loosen the five disc fixing screws.
- Thoroughly clean the seats on the front wheel
hub and on the disc.
See also
Removing the front wheel
Refitting
For fitting, position the disc correctly using the arrow stamped on it as reference.
- Do up the screws to the prescribed torque and apply the recommended product
Beverly 300 i.e. Braking system
BRAK SYS - 237
To Next Page
Loading...
