Make sure that the throttle valve with the control is
supporting the stop screw.
Guaranteeing that this position will be kept, send
a confirmation for the TPS reset procedure.
Reset should be performed in the following cases:
- on first fitting.
- if the injection control unit is replaced.
N.B.
THE TPS RESET PROCEDURE MUST NOT BE CARRIED OUT WITH A USED THROTTLE BODY
BECAUSE POSSIBLE VALVE WEAR AND STOP WEAR FOR THE MINIMUM OPENING MAKE THE
AIR FLOW DIFFERENTLY FROM THAT OF PRE-CALIBRATION.
Injection Beverly 300 i.e.
INJEC - 198
To Next Page
Loading...
