QNAP QTS 4.5 Series User Manual

Enabling Azure AD Single-Sign-On
Before starting this task, ensure that you create an application registration. For details, see https://
docs.microsoft.com/en-us/azure/active-directory/develop/howto-create-service-principal-portal. The user
interface on Microsoft Azure is subject to change without notice.
Important
You must first complete the following steps before enabling SSO.
• Ensure that your NAS has an x86 (Intel or AMD) processor.
• Configure Azure site-to-site VPN. For details, visit https://docs.microsoft.com/en-us/
azure/vpn-gateway/vpn-gateway-howto-site-to-site-resource-manager-portal.
You can also add a custom domain name using the Azure AD portal for the on-premise
Windows AD. For details, visit https://docs.microsoft.com/en-us/azure/vpn-gateway/
vpn-gateway-howto-site-to-site-resource-manager-portal and https://
docs.microsoft.com/en-us/azure/active-directory/fundamentals/add-custom-domain.
• Configure Azure AD Domain service. For details, see the following:
• Configuring AD Authentication Using the Quick Configuration Wizard
• Configuring AD Authentication Manually
Note
If you want to enable SSO on more than one NAS, you must repeat all of these steps on
each NAS.
1. Go to Control Panel > Privilege > Domain Security > SSO .
2. Select Enable Azure SSO Service.
3. Specify Client ID.
For details, visit https://docs.microsoft.com/en-us/azure/active-directory/develop/howto-create-service-
principal-portal.
Note
The Client ID is also known as an Application ID.
4. Specify Tenant ID.
For details, visit https://docs.microsoft.com/en-us/azure/active-directory/develop/howto-create-service-
principal-portal.
5. Specify Reply URLs.
a. Sign in as an administrator at portal.azure.com.
b. Click Azure Active Directory, and then click App registrations > Your app > All settings >
Reply URLS .
c. Add :8080/cgi-bin to the end of the IP address.
d. Copy and paste the URL into the Reply URLs field label on the NAS.
6. Specify the Public key.
Note
• The public key must be a PEM file.
QTS 4.5.x User Guide
Privilege Settings 101

QNAP QTS 4.5 Series Specifications

General

Operating System	QTS 4.5 (Based on Linux)
File System	EXT4
Supported RAID Levels	RAID 0, RAID 1, RAID 5, RAID 6, RAID 10, JBOD, Single
Networking Protocols	TCP/IP, IPv4, IPv6, SMB, NFS, AFP, FTP, SFTP, HTTP, HTTPS, iSCSI
Management Interface	Web-based GUI
Supported Protocols	SMB/CIFS, NFS, FTP, SFTP, WebDAV, AFP, iSCSI
Snapshot Support	Yes
Virtualization Support	Yes
Backup Solutions	Hybrid Backup Sync
Security Features	AES 256-bit encryption, Antivirus, IP Blocking
Mobile Apps	Qfile, Qmanager, Qphoto, Qmusic, Qvideo, Qnotes, Qcontactz
Maximum Storage Capacity	Varies by model. Dependent on the number of drive bays and the maximum capacity of individual drives supported.